East-coast-supercharging ECS Paxton SC1500 2010+ Camaro Supercharger Kit Manuel d'utilisateur télécharger pdf (Page 7)

37) From the bottom of the car use an impact gun to

remove factory balancer bolt.

38) Using the supplied pin fixture, thread bolt into

crank and align fixture flush to crank pulley.

39) Align supplied drill bit and crank dowels and

mark depth of dowel pins

40) Use drill supplied drill bit, with a dab of oil to

help facilitate cutting and Drill to marked depth in

both holes. Then Tap Dowel Pins into crank &

pulley.

41) Slide Main Blower drive pulley over dowels

being sure pulley seats fully into crank. Dowels

should be recessed slightly below pulley surface.

Install supplied crank pulley bolt, and tighten to

factory specs.

1 2 3 4 5 6 7 8 9 10 11 12 ... 24 25

Pas de commentaire

East-coast-supercharging ECS Paxton SC1500 2010+ Camaro Supercharger Kit Manuel d'utilisateur Page 7