Installation Guide for the East Coast Supercharging Gen V Camaro Supercharging System Guide for LS3 and L99 Equipped Vehicles V2 (4.2011)
19) We are going to be removing the stock air filter mounting tab on the driver’s side fender. Take a piece of cardboard and place as shown, to prote
22) Remove air box mounting stud on driver’s side fender with cutoff wheel. Proceed to cut tab from the side of the shock tower, then bending tab back
25) Replace factory alternator bracket with modified alternator bracket supplied in kit. Be sure to place supplied studs in the 3 upper mounting holes
29) Re-route injector harness over crossover coolant tube and re clip harness into fuel rail in factory location as shown below. 30) Using 3 of th
This page was intentionally left blank.
47) Install 2 supplied rubber grommets into lower intercooler support 48) Install Supplied Blow off Valve and Filter as shown on Intercooler (If not
52) Remove coolant line from factory oil cooler. This line will be replaced with re installation of upper radiator hose. 53) From top of car, place
56) Prior to reinstalling the Radiator, measure 3 inches up from the bottom of the lower radiator hose. Cut hose and install the supplied radiator ext
If your supercharger unit has not been clocked properly from the factory, use the picture above as a guideline to locating the oil drain line and the
58) Take upper radiator hose and swap ends as shown. The end that used to go to the block will now go to the radiator. Trim approximately 1.5 inches
1) Disconnect Battery and then remove engine cover. 2) Remove radiator Cap, and from under the car drain coolant by turning radiator drain valve a qu
60) Install Lower S tube from the Head unit outlet to the 90 degree hose on the inlet side of the intercooler and attach to intercooler inlet duct w
64) With spring tensioner in its fully open position, Install provided 080720 8rib blower belt, and head unit pulley by placing belt over crank, under
72) installing the catch can. The Catch can is inserted between the engine valley tray and the intake manifold. 73) install Catch can with check va
Remove inner quarter panel by pulling towards center of car, exposing the fuel pump control module Mount Boost a pump securely to floor board, unde
Using supplied connectors, connect the orange wire from BAP to the plug side of the red and white wire going to the FCPM. Next, take the red fused wir
Install supplied 60-lb. injectors with brown O rings on the intake manifold side. Install the TR6 spark plugs gapped to .035 inch.FINAL CHECK AND MAIN
7) With a 15mm socket remove power steering idler pulley. 8) With a 10mm socket, remove upper radiator support brackets. 9) Place upper radiator
11) Remove upper radiator hose and set aside for later reinstallation removing clamps at block, radiator & oil cooler line by the front of oil pan
15) Using a pick tool, or suitable other tool, remove c-clips retainers from transmission cooling lines and place in factory provided bracket on the b
33) Using the 4 supplied 3/8th x16 x 4.75 long bolts and spacers install supercharger mounting plate over PS pump into back mounting plate. Torque to
37) From the bottom of the car use an impact gun to remove factory balancer bolt. 38) Using the supplied pin fixture, thread bolt into crank and al
This page was intentionally left blank.
42) Remove lower radiator shroud by pulling plastic retaining pins, folding edge and pulling it out the bottom of the car. 43) Trim IAT Sensor moun
Commentaires sur ces manuels